Any questions?
>
Composite End Slats for Straight Installation
Sold as a set of 2, these composite end slats provide a clean, finished look for your straight-line fence installation. Each slat stands 1.90m tall and can be trimmed to fit your fence panel. The durable material is UV- and weather-resistant, requiring no maintenance.
Composite end slats are designed to give your straight-line fence panels a neat, professional finish. Each pack includes two slats, each 1.90m high, which can be easily cut to match your panel height.
Made from composite wood, these slats are built to withstand harsh weather and UV exposure, and require no ongoing maintenance. They’re an essential accessory for a long-lasting, tidy fence installation.
Additional Information
Sold in packs of 2 x 1.90m (can be trimmed to fit heights of 1.03m, 1.23m, 1.53m, and 1.73m)
Benefits of Composite End Slats for Straight Fence Kits
- Clean finish: ensures a precise, seamless line between your rigid fence panels and posts.
- Durable material: high-quality composite wood resists UV rays, frost, and harsh weather.
- Low maintenance: rot-proof slats that never need painting, staining, or yearly treatment.
- Versatile fit: 1.90m slats can be trimmed to suit any fence height.
How to Install End Slats on a Composite Fence Kit
End slats, also known as edge boards, are installed first and last in your rigid mesh fence panel, on the post side. Before installation, trim each slat to the required height using a circular saw with a fine-tooth carbide blade. Start by inserting the first end slat into the outermost mesh next to the left post. Slide it down vertically to the bottom rail, then clip it onto the retaining bar to secure it. Repeat on the opposite side of the panel. Internal slats are then fitted to fill the center space. Be sure to leave at least 1 cm between the bottom of the panel and the ground to make slat insertion easier and prevent contact with ground moisture.
Available colours
Gray 7016
Light wood
- Height
- 6 ft 3 in
- Thickness
- 4 mm
- Slat width
- 43 mm
Getting a clean installation starts with precise cutting. Boards measuring 1.90m need to be trimmed to match your panel height—1.03m, 1.23m, 1.53m, or 1.73m—before fitting. Use a straight pencil line and make a clean cut to ensure a flush fit with no gaps or overhang.
Vertical alignment is just as important. Always check each board with a level before securing it in place. Even a slight misalignment will be noticeable once the panel is finished.
Consistent clipping on each horizontal wire is key for long-term stability. If the board is too loose, it may rattle in strong winds. Properly secured, it provides a stable, uniform finish along the entire panel, regardless of height.
In the same category
Our customers also bought
Get Districlos news, deals and inspiration in your inbox!
